I am using gns3 2.1.11 version, and I have imported the appliance as you described in the article, and that is the one having an issue, Like it boots sometimes, and sometime gets stuck in loader prompt, even if I issue boot command, it goes back into loader. When it reloads you should be at the switch prompt and not go through the abort auto-provisioning stuff. Switch(config)# boot nxos bootflash:nxos.7.0.3.I2.2d.bin <- Note: use correct image name from "dir" command output If the nx-osv 9000 drops you into the loader prompt, then start back at step 1.Įnter configuration commands, one per line. If you do not type in ‘y’ in the required amount of time, the nx-osv 9000 will, by default, drop you into the loader prompt.
Very important, in the ensuing video, pay extreme attention to typing in ‘y’ when you start the nx-osv 9000 and it asks you to Abort Auto-Provision
Okay, I see some mistakes in my instructionsġ) delete the nx-osv 9000 from your gns3 workspace in your projectĢ) from the gns3 toolbar->Edit->Preferences->QEMU VMs->select the nx-osv 9000 in questionģ) if necessary, scroll down on the right side of that popup and select DeleteĤ) Then you have to click Apply, or OK, and OK, and OK to get back to the gns3 workspaceġ0) do NOT start the nx-osv 9000, but drag it into your workspace
0 kommentar(er)
